Alphabetical search:  A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z   All 
Please enter search here:


Entries found for search: bias

AC bias : See bias.

bias : (1) Bias is the voltage or current that establishes the intrinsic noise floor of an active device. (2) In an analog tape recorder, bias is an ultrasonic signal, usually between 100k Hz-200kHz, which is mixed with the audio signal and applied to the recording head, reducing distortion by reducing the hysteresis inherent in the tape recording process. This process is known as AC bias because the bias current is alternating. The ideal setting of analog bias involves a compromise between the MOL of the tape, noise, and third-harmonic distortion. In general, classical recordings use a bias setting with lower distortion and lower MOL; rock or other recordings prefer a higher distortion in order to get the highest S/N ratio. Digital recorders do not require bias as the signal consists only of a bitstream of 0s and 1s, regardless of the audio frequency being recorded. (3) See electric microphone.

biased noise : A tape loop of audio silence, processed by a recorder with some kind of noise-reduction enabled, such as Dolby-SR (where it is called SR noise) or dbx or dB. Used to check equipment for ground loops or other problems in recordings and/or masters. Sometimes called an alignment recording. See Dolby noise.

overbias : The use of more bias current in an analog magnetic recorder than is required for maximum sensitivity. Overbias will reduce the distortion and the sensitivity to dropouts, but will also reduce the high-frequency response, so compensatory equalization control must be applied.

tape bias : See bias.



site design Dan Rugh and Steve Kunath